Diesel Generator Sets:
3612 Generator Set (Medium Speed)
Contact Us About This Product
Click a link to download the document:
- Bore
- 11 in
- Displacement
- 1127 in3
- Stroke
- 11.8 in
- Aspiration
- TA
Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.
Product Specs
-
Engine Specifications
- Bore
- 11in
- Displacement
- 1127in3
- Stroke
- 11.8in
- Aspiration
- TA
- Fuel System
- Direct unit injection
- Aspiration
- TA
- Fuel System
- Direct unit injection
- Bore
- 11in
- Displacement
- 13524in³
- Stroke
- 11.8in
- Fuel System
- 13524in³
- Engine Model
- 3612 V-12,4-Stroke Water-Cooled Diesel
- Total Displacement
- 13524in³
- Compression Ratio
- 13:01
- Governor Type
- Generator Set Monitoring System (GMS)
-
Generator Set Specifications
- Duty Cycle
- Prime, Continuous
- Minimum Rating
- 4400 kVA
- Maximum Rating
- 4850 kVA
- Frequency
- 50 Hz
- Speed
- 750 & 1000 rpm
- Emissions/Fuel Strategy
- Low Fuel Consumption
-
Generator Set Dimensions
- Length - Maximum
- 404in
- Width - Maximum
- 99.62in
- Height - Maximum
- 156.6in
- Dry Weight - Genset (maximum)
- 112690lb
Equipment
-
- Air Inlet System
-
- Air cleaner
- Turbocharger, watercooled, engine oil lubricated
- Breather, crankcase, top-mounted
- Aftercooler, fresh water, corrosion resistant coated (air side)
- Air inlet shutoff
-
- Cooling System
-
- Water temperature regulator
- Engine coolant water drains
- Jacket water thermostats
- Front mounted turbos
- Three-bundle oil cooler
-
- Exhaust System
-
- Dry, gas tight, exhaust manifold
- 457 mm (18 in) Cat bolt pattern
- Includes adapter, flexible exhaust fitting
-
- Fuel System
-
- Simplex or duplex
-
- Generator System
-
- Custom generator per generator data sheet completed by dealer
-
- Governor System
-
- UG actuator
-
- Lube System
-
- Centrifugal oil filters with single shutoff
- Oil filler and dipstick
- Crankcase explosion relief valves
- Oil pressure regulating valve
- Wet oil sump. Includes engine-driven main lubrication & oil pumps, Oil Lines and Oil Pan
- Service side engine mounted on cylinder block inspection covers
-
- Mounting System
-
- Damper, torsional vibration
- Engine and generator mounting
-
- Starting / Charging System
-
- Line group for single point custom connection
- Vane type air starter
- Two motors, engine mounted at rear, on left side
- Air silencer
-
- General:
-
- Paint, Caterpillar yellow
- Gear driven pumps: Fuel, Oil, Jacket water, Aftercooler / Oil cooler water
-
- Air Inlet System
-
- Vertical support bracket
- Soot filter
- Boost control valve
- Heavy duty air cleaner
- Air cleaner louver assembly
- Air inlet adapter
-
- Cooling System
-
- Heating aids
- Auxiliary water pump
- Expansion tank
- Heat exchanger for single circuit
- Cooling system aids
-
- Exhaust System
-
- Flexible exhaust fittings
- Weld flange and related hardware
-
- Fuel System
-
- Duplex primary fuel strainer
- Fuel system connections
- Fuel priming pump
-
- Generator System
-
- Anti-condensation space heaters
- Class F insulation
- Busbar connections
- Winding temperature detectors
- 3 Phase, six Leads, WYE
-
- Governor System
-
- 230 UA
- EGB actuator
- Digital programmers
- Electronic / actuators
- 723 Plus
- Battery backup / Power supply
-
- Lube System
-
- Oil pan drain valve
- Lube ANSI adapter (Emergency connection)
-
- Mounting System
-
- Spring type vibration isolator
- Vertically restrained
- Isolator
- Non-vertically restrained
-
- Starting / Charging System
-
- Compressed air flex hose
- Redundant Air Starters
- Pressure reducing valve
- Turbine type air starters
-
- General:
-
- Custom paint colors