Auxiliary Engines:

Cat C280 Marine Auxiliary Engines

C280 Aux
Minimum Rating
2320.0 bhp
Aspiration
TA
Configuration
In-Line 6, Vee 8, Vee 12, Vee 16, 4-Stroke-Cycle Diesel
Bore
11.0 in


Product Specs

  • Power Rating

  • Minimum Rating
    2320.0bhp
    Minimum Rating
    2320BHP
    Maximum Rating
    7268BHP
  • Engine Specifications

  • Aspiration
    TA
    Configuration
    In-Line 6, Vee 8, Vee 12, Vee 16, 4-Stroke-Cycle Diesel
    Bore
    11.0in
    Stroke
    11.8in
    Aspiration
    TA
    Bore
    11in
    Configuration
    In-Line 6, Vee 8, Vee 12, Vee 16, 4-Stroke-Cycle Diesel
    Stroke
    11.8in
  • Dimensions & Weights

  • Minimum Length
    145.0in
    Maximum Length
    197.0in
    Maximum Width
    69.0in
    Minimum Width
    67.0in
    Minimum Height
    108.0in
    Maximum Height
    140.0in
    Minimum Dry Weight
    34496.0lb
    Maximum Dry Weight
    62832.0lb
    Maximum Dry Weight
    62832lb
    Maximum Height
    140in
    Maximum Length
    197in
    Maximum Width
    69in
    Minimum Dry Weight
    34496lb
    Minimum Height
    108in
    Minimum Length
    145in
    Minimum Width
    67in

Equipment

  • Air Inlet System
    • R INLET SYSTEM Aftercooler, fresh water, corrosion resistant coated (air side) Air inlet shutoff Breather, crankcase, top-mounted Turbocharger, rear-mounted, engine oil lubricated
  • Control System
    • Single Caterpillar A-III Electronic Engine Control Modules with Electronic Unit Injector Fuel System Rigid Wiring Harness (10 amp 24volt power required to drive Electronic Engine Control Modules)
  • Cooling System
    • Engine coolant water drains
  • Exhaust System
    • Dry, gas tight, exhaust manifold
  • Fuel System
    • Distillate fuel (requires viscosity ranging from 1.4 cSt to 20 cSt at 38 degrees C) Fuel transfer pump (mounted on left hand side) Duplex fuel filters Electronically Controlled Unit Injectors
  • Lube System
    • Centrifugal oil filters with single shutoff. Service side engine mounted on cylinder block inspection covers. Includes installed oil lines and single shutoff valve. Filters centrifuge bypass oil from the main lubricating oil pump. Can be serviced with the engine running. Oil filler and dipstick Valve, oil pressure regulating Valves, crankcase explosion relief
  • General
    • Paint, Caterpillar yellow Pumps, gear driven: fuel, oil, jacket water, aftercooler/oil cooler water
  • Svce Tools/ship Prot/factory Support
    • Service literature. Included standard with each engine are two (2) complete sets of service literature listed below: 1. Custom parts book CD (serial number specific) 2. Service manual, which includes: Operation & Maintenance, Specifications, Systems Operation, Testing and Adjusting, Disassembly and Assembly manual. Available in paper media and English language only. 3. Technical manual (parts/service information for special equipment). Available in paper media in English language only. NOTE: Custom parts book CD and service manual can be re-ordered through the normal Caterpillar literature ordering system. The technical manual can only be re-ordered through the Project Services at the Caterpillar Lafayette Engine Center facility.
  • Air Inlet System
    • Air Cleaners
  • Cooling System
    • Jacket Water Heaters
    • Heat Recovery System
    • Heat Recovery Thermostats
    • Cooling System Connection Groups
    • De-Aerator
  • Control System
    • Load Sharing module
    • Direct Rack Module
  • Exhaust System
    • Outlet Expander
    • Flexible Exhaust Fittings
    • Weld Flange - Optional
  • Fuel System
    • Fuel Priming Pump
    • Duplex Primary Fuel Strainer
    • Fuel System Connections
  • Lube System
    • Oil Pan Drain Valve
    • Prelubrication Connections
    • Lube Oil Heater
  • Mounting System
    • Vibration Isolators
  • Marine Society Requirements
    • Spray shielding
  • Protection System
    • PLC Monitoring System Options
    • ECP Relay System Options
    • ECP Mechanical Gauge Instrument Panel
    • Turbocharger Speed Sensor
    • Cylinder Pressure Relief Valve
    • Oil Mist Detector
    • Protection System Components
    • Magnetic Pickup
  • Spare Part Kits
    • Intake and Air System
    • Basic Engine
    • Cylinder Head
    • Fuel System
    • Cooling System
    • Instrumentation
    • Cylinder Valve Kits
  • Engine Testing
    • Basic System Testing
    • Special Witness Test
    • Torsional Vibration Analysis
  • Service Tools / Shipping Protection / Factory Support
    • Commissioning
    • Service Tools
    • Factory Packaging
    • Shipping Protection-Shrink Wrap or Tarp
    • Shipping Protection-Export Boxing
    • AID Emblem
    • Storage Preservation

Request a Quote

Find a Boyd CAT
Location or Rep Near You